Sanding Archive
-
How To Do Light Checking
Posted on February 11, 2012 | No CommentsLight checking is a very important step. In this step we will buff out nicely everything we coated with a sponge. I'd have to say this is my least favorite part of the process, but one of the most important. For you to see all the areas that need to... -
How To Sand Drywall With A Pole Sander
Posted on October 3, 2011 | No CommentsPole Sanding Angles And Nails Unless you’re using a sponge or a sanding pad between your sander and the paper, you will notice your paper will either have to be cut, or folded to fit properly into the Super Sander Drywall Sanding Tool. Put your paper square on the sanding pole... -
Rough Sanding Angles And Drywall Butt Joints Before Final Coat
Posted on July 28, 2011 | No CommentsRough sanding is a very important step in the taping process. You need to use a rough paper like the 100 grit paper to eliminate the lumps and lift off left from the previous coats. There are 2 steps involing rough sanding, first we sand the flat joints, the butt... -
Finish Sanding Final Touch-Ups
Posted on May 18, 2011 | No CommentsTo sand the touch-ups which we have applied in the previous steps, were going to need a brand new sponge. You need a new sponge which as a rough side that's not warn down too much, you need the rough side to remove the edges of the touch-up. If you...